6.5" Rear Speaker Pod Upgrade Installation Guide I '21- Current Bronco

Welcome to your Bronco 6.5" Rear Pod Speaker Installation Guide. 

The following will walk you through the entire installation which includes a video at the bottom to follow along.    

If you have any questions at all, or need anything during the installation, we're only a phone call away and we're available Monday-Friday, 9am-5pm est. for any support needed, or you can shoot us an email at support@trailseven.com.  

These installation notes are intended to be used in conjunction with the installation videos based on the your bundle.

Rear Roll Bar 6.5" Upgrade (Trail Seven Pods): 

1. Removal: Rear Roll Bar speakers will follow as demonstrated in the video. 

2. Installation:

• Loosen the top factory metal bracket on top of the roll bar. 
• Raptor- This is a tight fit, however by pushing the front of the pod up first, then lowering it in position will ease the installation. 
• Connect speaker connector
• Insert provided top bolts into speaker pod, hand tighten
• Insert factory bolt into the side of the roll bar, hand tighten
• Tighten top bolts (factory and new)
• Tighten side bolt 

3. Trail Seven Rear Pod Installation Video:

Rear Roll Bar 6.5" Upgrade (MTI Pods): 

1. Removal: Rear Roll Bar speakers will follow as demonstrated in the video. 

2. Installation:

• You will need to transfer the factory connector from the pods to the new MTI pods.  Remove the connector using a small flat head screw driver and transfer the connector with the grommet over to the MTI pod. 
• Mount using the provided hardware but do not mount the speakers until the pod has been mounted. 

3. Trail Seven MTI Rear Pod Installation Video:

Rear Roll Bar 6.5" Upgrade (SSV Pods):

1. SSV Works Rear Pod Installation Video: