Alpine SBV-10-WRA Pre-Loaded 10" Subwoofer | '07-'18 Jeep JKU Wrangler Unlimited

Smart Use Of Space With Easy Installation: When you have a Wrangler, you don’t have extra space to spare. Alpine engineered the SBV-10-WRA to conveniently fit under the front passenger’s seat making efficient use of space. The SBV-10-WRA is a custom-shaped enclosure that fits snugly under the seat frame, so no mounting hardware is required. (NOTE: designed for fitment in Jeeps with the factory carpet. Fitment is not guaranteed with aftermarket or removed carpet)

• Installation Note: The Alpine 10" Water Resistant Subwoofer is designed for use with factory carpet. If your Jeep does not have carpets, additional padding may be required.  Designed to be used with the Alpine MRV-M500 Mono V-Power Digital Amp (sold separately). 
• Not Compatible with 2-Door Wranglers
• Estimated Installation Time: 1-2 Hours 

Wrangler-ready Bass: Enjoy impactful bass, with your Wrangler’s top on or off. The SBV-10-WRA loads the lower frequency sound into the passenger’s foot well to deliver quality sound and maximized bass extension at all times, so your music continues even when the asphalt ends.

Weather Resistant: Driving with the top off is part of the fun of owning a Wrangler, but you sometimes get caught off-guard with the top down and inclement weather. The SBV-10-WRA is weather resistant and rated IP66, so it’s protected from total dust ingress and water from any direction.

Custom Fit for Jeep® Wrangler (2011–2018, JK): Designed to seamlessly install under the passenger seat without sacrificing space.

Powerful Bass Performance: 10” subwoofer delivers deep, impactful low-end for a full, balanced sound.

Pre-Loaded & Ready to Install: Comes pre-mounted in a rugged, sealed enclosure for easy plug-and-play setup.

Vehicle-Specific Design: Maintains factory look and feel while enhancing your audio system’s performance.

Built Tough for the Trail: Durable enclosure construction stands up to heat, moisture, and rough conditions.

Optimized for Alpine Amplifiers: Pairs perfectly with Alpine power for maximum output and clarity.

• 10" subwoofer pre-loaded into a sealed, custom-fit enclosure
• Designed to be pressure fit under the front passenger’s seat rails, no mounting hardware is required
• Trail Ready - Rated at IP66 for protection against total dust ingress and water from any direction
• OEM-grade weather resistant Molex 2-pin connector with pigtail wire harness
• Nominal Impedance: 2 ohm
• Frequency Response: 45-200Hz
• The 300W RMS/900W max power rating is a match for the KTA-30MW Mono Tough Power Pack Amplifiers

Size: 10"

• Shipping Weight: 22lbs
• Shipping Dimensions: 20in x 19in x 12in (L x W x H)

Subwoofer Housing

• Subwoofer Speaker
• Wiring Pigtail
• Pre-loaded 10" subwoofer enclosure w/attached 4" wiring harness
• Matching wire harness w/4" bare-ended 12 AWG wire
• Warranty registration sheet w/serial#
• Warranty coverage sheet
• Safety and warnings